If the measurements obtained with an 'Other' adapter is not suitable, please use a Preferred Adapter. WHAT YOU SEE IS WHAT YOU GET WITH ANY ADAPTER THAT IS LISTED AS OTHER. Due to the inability to disable roaming on the adapter, only by SSID (not by AP) are available for active and iPerf surveys.There is no roaming control for active and iPerf surveys.Refer to “Utilizing Multiple Adapters” in the AirMagnet Survey User Guide. Only one 802.11ac adapter can be used when utilizing multiple adapters.Limitations in the wireless channels that they scan: They may only be able to scan channels that are approved for wireless use in a specific country, and unable to scan channels assigned as Dynamic Frequency Selection (DFS) channels.iPerf throughput performance may vary, depending on the model of the generic adapter in use.No packet retry and loss measurements on active and Iperf surveys.Only a single PHY data rate for the connection is reported. Measured PHY data rates in the uplink and downlink directions are not separated.No noise or signal-to-noise ratio (SNR) measurements.There is no Scan or 802.11 tab under the File>Configure menu. No ability to scan specific channels: all channels are scanned.The following are noted limitations of ' Other' adapters in AirMagnet Survey. These adapters' drivers have not been customized, provide limited feature support, and could provide inaccurate information. NetAlly is not responsible for the quality of the test results collected using these adapters. Other adapters can be used with AirMagnet Survey PRO to perform a survey but have not been tested by AirMagnet. Drivers have not been customized, will provide limited features, and could provide inaccurate data.Īny 802.11 adapter supported by Windows that is not a Preferred adapter falls into the Other network adapters category. These adapters can be used with AirMagnet Survey PRO but have not been tested by NetAlly. ![]() NETSCOUT 3x3 Express Card 802.11ac– noise on passive survey only.Alfa AWUS1900 - no noise readings available.Proxim 9100 - no noise readings available. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |